Filter

My recent searches
Filter by:
Budget
to
to
to
Type
Skills
Languages
    Job State
    9 jobs found, pricing in AUD

    I want to mesh a square cylinder enclosed in a rectangular domain. Dimensions are: side of square cylinder: 1 m upstream distance: 20 m downstream distance: 40 m height of domain 60 m I am enclosing a sample 2D mesh. The project is to create a 3D mesh so that I could do numerical simulations on it with dynamic meshing. Dynamic meshing setting will be done in the circular zone near the square cylinder.

    $118 (Avg Bid)
    $118 Avg Bid
    9 bids

    I want to mesh a square cylinder enclosed in a rectangular domain. Dimensions are: side of square cylinder: 1 m upstream distance: 20 m downstream distance: 40 m height of domain 60 m I am enclosing a sample 2D mesh. The project is to create a 3D mesh so that I could do numerical simulations on it with dynamic meshing. Dynamic meshing setting will be done in the circular zone near the square cylinder.

    $149 (Avg Bid)
    $149 Avg Bid
    6 bids

    I need to find traction and slip on a wheel

    $140 (Avg Bid)
    $140 Avg Bid
    14 bids

    I am working on Non-Isothermal PE-100 pipe extrusion. I am applying cross law for viscosity dependence on shear rate and Arrhenius law for viscosity dependence on temperature in direct extrusion at POLYFLOW. When i run, it shows solution is not converge. When I change the viscosity to be not temperature dependent, then the solution can be converged. So there is any way to make it converge and in the same time take the temperature into account to determine the viscosity? where I am wrong? I am struck here. Kindly help me.

    $24 (Avg Bid)
    $24 Avg Bid
    5 bids

    We've to perform CFD (Flow Simulation) of a Vertical Axis Wind Turbine.

    $28 (Avg Bid)
    $28 Avg Bid
    7 bids
    CFD expert 23 hours left
    VERIFIED

    To do a task with report, contact me for more details

    $115 (Avg Bid)
    $115 Avg Bid
    32 bids

    i want to model and design coaxial pseudo magnetic gear with a gear ratio of g1-g2:6.45, g2-g3: 9.14 total gear ratio of 59.012987. the modeling will be first done using a Permanent magnet and then PPM-PM key parameters of interest are transferable torque limit, roto size, toque density, etc

    $206 (Avg Bid)
    $206 Avg Bid
    12 bids

    need to perform an acoustic analysis to reduce the noise in the aqua silencer to 80db

    $81 (Avg Bid)
    $81 Avg Bid
    9 bids

    In this project we need to reduce the noise from the silencer to 80db with changing design of silencer

    $126 (Avg Bid)
    $126 Avg Bid
    7 bids