STM32 Cube IDE
$30-250 USD
Paid on delivery
We would like an expert to help us modify the code using STM32 Cube IDE and reading the value from the sensors using Tera.
The sensors were using is current sensor INA219, and GY-801 10DOF IMU, which is comprised four types of sensors using I2C interface, ( ADXL345 three-axis accelerometer) , (L3G4200D three-axis angular rate sensor (gyroscope)), (HMC5883L three-axis digital compass (magnetometer)), and (BMP180 piezo-resistive sensor (Barometric Pressure and Temperature sensor)).
Project ID: #32247966
About the project
15 freelancers are bidding on average $295 for this job
Hi, I'm an embedded systems developer with experience with STM32 HAL development & I have solid knowledge of writing I2C & SPI sensors drivers. Please contact me to discuss more details about your project, Regards
I have more than 9 years experience in embedded hardware and firmware development . And I have done many projects based on stm32 . So I can do your job within a time limit with your satisfaction.
Hello, I hope this finds you well. I have just seen your project requiring; Electronics Raspberry Pi STM32 I believe that my 10-year experience in this field is what you need right away. Avoid the headache of looking More
Hi! I have understood your requirnments about your project with every detail of it. I am an Electrical Engineer with more then 9 years experience in electronics, circuit design, PCB layout, Verilog, FPGA, Embadded Syst More
Dear client, I am an experienced embedded system engineer, I worked on many projects based on stm toolchains such as robot control systems and industrial data acquisition systems. I am very familiar with STM microcontr More
As An Embedded engineer most of my previous projects were based on STM32 Microcontrollers of ARM cortex M4 and M7 and most often used IDEs are STM Cube IDE, STM cube Mx, Keil and others. Capable to work on any STM bas More
I used most of the sensors you mentioned in my UAV Flight controller project, which I previously made using the STM32 series. I had already designed their library as some sensors are the same. For the raw data obtained More
I'm electronic engineer. I have Arduino, STM32 skills. I did some project with them. I can do it. You can contract with me
