drone project, UAV Autonomous Flying

Hello, I have 10+ years of Experience in Embedded HW product design with multiple domains like a consumer, industrial, automotive, IoT, and wearable products. -Hardware architecture design using MCU, controller, and FPGA, as well as low power battery, operated device -Experience in all phases of product development from prototyping to mass production -Experience in Schematic design and high-speed PCB layout board design with multilayer PCB design, Blind & Buried Vias in HDI Design. -Working experience on power management system design with Buck-boost, Battery charger, and fuel gauge, USB3.0 Ctype and PD charging, POE and etc -Expertise in design and simulation of analog circuits, -Experience in Microprocessor and microcontrollers like NXP, ST, Microchip, Marwell, Qualcomm, MediaTek, TI, Renesas, and Atmel -Exposure in mechanical design review -Expertise in wireless SOC with Bluetooth, WIFI, 4G, Lora, Zigbee from NXP, Nordic, Ublox, Qualcomm, Cypress, Broadcomm, TI, ESP, Silabs, Microchip -Experience in wire interface USB2/3, SPI, I2C, UART, HDMI, Ethernet, SDIO, MIPI-CSI/DSI, CAN, Modbus, RS232, RS485 -Expertise in solving problems of EMI/EMC -EMI / EMC compliance testing and product certification like CE/FCC/UL and etc -Expertise in hardware testing and troubleshooting/root cause we will define milestones and adjust the amount after discussion Let me know if you need help from me. Thanks. --Alpesh

I have worked on deepstream and jetson stack before too . Being a backend and a AI developer i am sure I can better understand your need and will try to deliver in time.

Hi, I am flight controls engineer with 5 years of experience. I am currently working on this domain. I will be able to help you, if you are planning pixhawk and px4. However, the scope of work and budget is not compatible. If you are able to clearly define your objective. I can propose the budget and solution for it.